Zinsser Jomax Mold & Mildew Stain Remover

Description

JOMAX® Mold & Mildew Shield™ creates an invisible surface barrier against the growth of mold & mildew on interior and exterior surfaces. The easy to use, fast drying formula applies white to show coverage and dries clear. Just spray on and gently buff with a clean cloth to coat the surface. When applied according to label directions, it protects for up to three months.

Extended Information

DIRECTIONS FOR USE

Remove all loose dirt, oil, grease, and other contaminants.

Rotate the nozzle to spray position for large areas. Rotate the

nozzle to stream for a concentrated jet spray on hard to reach

areas.  Apply directly to soiled areas. Wait 5 to 10 minutes

for stains to disappear and then rinse thoroughly with water.

For difficult stains, some scrubbing may be necessary. Wipe dry,

using a clean cellulose sponge, cloth or paper towel. For

sensitive skin, wear gloves.

Coverage: 1,000 sq ft per quart

Note:

This product may not be compatible with all surfaces and

all conditions surrounding the application. Before applying to any

surface, always test product in a small inconspicuous area to

ensure no damage will result. Use with adequate

ventilation at all times. During use, a NIOSH approved respirator is advised.

*Do not mix this product with other chemicals and do not use

on varnished surfaces, granite, marble, silver, brass or

leather.

CAUTION!

Avoid contact with eyes and skin. If eye contact

occurs, flush with water for at least 15 minutes. If irritation persists,

seek medical attention. Do not take internally.

KEEP OUT OF REACH OF CHILDREN.

DISPOSAL

The empty container can be recycled. If recycling is not available,

discard in trash.