Home > Paint & Stains > United Gilsonite (UGL) >

UGL Drylok Latex Bonding Agent

UGL Drylok Latex Bonding Agent
UGL Drylok Latex Bonding Agent


 
DRYLOK® Latex Bonding Agent bonds concrete and plaster to difficult surfaces such as dense, slick or porous concrete, stone, drywall, hardboard and plaster walls. When used as an additive to concrete mixes for patching, DRYLOK® Bonding Agent improves the adhesion and increases the resiliency and elasticity of the patch. DRYLOK® Bonding Agent may also be used for pointing of plaster cracks

Item# Item Name List Price Our Price Qty Add
22213-1 UGL Drylok Latex Bonding Agent Gallon
$49.83
$40.88
22213-1BOX UGL Drylok Latex Bonding Agent Gallon - (Box of 2) Save by the box: $38.58 ea
$99.65
$77.16
22212-1 UGL Drylok Latex Bonding Agent Quart
$18.17
$14.92
22212-1BOX UGL Drylok Latex Bonding Agent Quart - (Box of 4) Save by the box: $13.98 ea
$72.67
$55.92
Check the items you wish to purchase, then click


Extended Information:
Bonds masonry to masonry, and concrete and plaster to difficult surfaces. Also makes cement, stucco and plaster adhere better.

COMPOSITION: N/A
SHEEN: N/A %
WEIGHT SOLIDS: 30%
% VOLUME SOLIDS: 25%
DENSITY (LBS./US GAL.): 8.60
VISCOSITY: N/A
pH: 9.3
COLORS: N/A


DRY TIME: • When added to concrete mixes: N/A • When used before topcoating with plaster or concrete: 30 minutes • When added to powder waterproofers: N/A Note: Maximum cure and dry time will be prolonged when slightly humid and damp, cool conditions prevail.

CLEAN UP: Soap and water Dispose of contaminated absorbent, container and unused contents in accordance with local, state and federal regulations.

COVERAGE (SQ. FT./US GAL.): • Up to 500 sq. ft./gal. Note: Actual coverage will vary depending upon application method, surface texture and porosity.

RECOMMENDED FILM THICKNESS/COAT: N/A
FLASH POINT: N/A
SHELF LIFE: N/A
FREEZE/THAW: Keep from freezing

Surface must be clean, dry and free of oil, grease and powdery or peeling materials. Protect from freezing.
NOTE: Protect from freezing. If Bonding Agent arrives in a frozen condition, allow to thaw at room temperature for 24  hours before using. Use only when air and surface temperatures are above 50ºF.

If you scrape, sand, or remove old paint, you may release lead dust. LEAD IS TOXIC. EXPOSURE TO LEAD DUST CAN CAUSE SERIOUS ILLNESS, SUCH AS BRAIN DAMAGE, ESPECIALLY IN CHILDREN. PREGNANT WOMEN SHOULD ALSO AVOID EXPOSURE. Wear a NIOSH- approved respirator to control lead exposure. Clean up carefully with a HEPA vacuum and a wet mop. Before you start, find out how to protect yourself and your family by contacting the National Lead Information Hotline at 1-800-424-LEAD or log on to www.epa.gov/lead.

To Strengthen Concrete Mixes: Slowly add DRYLOK Latex Bonding Agent to cement powder (1 quart DRYLOK Latex Bonding Agent to 3 parts cement powder for normal repairs) stirring constantly until consistency is smooth. Adjust consistency if necessary by adding additional latex or cement.

When repairing small cracks, mix DRYLOK Latex Bonding Agent and concrete powder to a thin consistency; for deep or wide repairs, use a heavy consistency.

To Patch or Repoint: Brush or spray Bonding Agent on the surface to be repaired. Apply full strenth. Do not thin.  Once DRYLOK Latex Bonding Agent changes from milky color to a clear glaze (approx. 30 minutes) it is dry and ready for a top coating of plaster or concrete.

To Improve Powdered Waterproofers: Mix DRYLOK Bonding Agent with water in a one to one ration and use his mixture instead of water to prepare the powdered masonry waterproofer.

Avoid prolonged contact with skin. Close container after each use.

DO NOT TAKE INTERNALLY. KEEP OUT OF REACH OF CHILDREN

This product contains a chemical known to the State of California to cause cancer.





Share your knowledge of this product with other customers... Be the first to write a review

Browse for more products in the same category as this item:

Paint & Stains > United Gilsonite (UGL)
Paint & Stains