Extended Information:
DESCRIPTION: Penetrating clear satin waterproofer primarily for vertical surfaces; water-based acrylic, low odor and low VOC.
Typical Uses: ✓ Seal brick, stucco & concrete ✓ Rejuvenate old brick & plaster ✓ Brighten aluminum siding ✓ Prime vinyl siding ✓ Bind chalky surface ✓ Paint additive to extend life & coverage ✓ Buffer pH in hot cement ✓ Dustproofing and priming floors
Important:
Read all directions thoroughly. Recommended: Wear gloves and safety glasses.
SURFACE PREP*:
Surface must be clean and dry. Remove loose paint and excessive chalk. Repair cracks and surface breaks. Cover windows, doors, etc. and use caution when applying on windy days.
APPLICATION:
Read “LIMITATIONS” section before use. This sealer is ready to use; do not dilute. Apply with a brush, roller or sprayer (garden or airless). Backroll spray applications to ensure penetration. Apply at least two coats, allowing two hours dry time between coats. Remove any overspray immediately with water. Note: Sealer goes on milky white but dries clear.
COVERAGE:
80–300 sq.ft. per gal., depending on surface porosity. Second coat application is 50% greater. Two coats are required for waterproofi ng bare, vertical concrete.
DRY TIME:
2–4 hours, depending on temperature and humidity.
TOPCOATING:
May be topcoated with latex, oil-based or elastomeric coating when dry.
TINT LIMITS:
Up to 4 oz. colorant per gallon.
PAINT ADDITIVE:
4–8 oz. of SEAL-KRETE Original can be mixed with one gallon of latex paint to improve spread rate.
CLEAN-UP & STORAGE:
Clean all tools immediately after use with soap and water. Store unused product in a dry place above 32°F (0°C). KEEP FROM FREEZING.
LIMITATIONS:
Use on above grade vertical surfaces or as a primer on horizontal surfaces – not for below grade use. Do not apply if rain is expected within 12 hours or if temperatures fall below 50°F within 24 hours of application. Do not use on swimming pools, bird baths, water features, cedar, redwood or in areas where hydrostatic pressure is likely to develop. Do not use on very porous substrates like low density, decorative block (use SEAL-KRETE Heavy-Duty instead).
| 
