Home > Paint & Stains >

Rust-Oleum Stops Rust Cold Galvanizing Compound Spray 7785830

Rust-Oleum Stops Rust Cold Galvanizing Compound Spray
Rust-Oleum Stops Rust Cold Galvanizing Compound Spray


 
Rust-Oleum Stops Rust Cold Galvanizing Compound Spray applies galvanized finish to galvanized and sheet metal. Use on wrought iron and spot-welded metal, gutters, chain-link fences and more. Dries into a 93% pure zinc film.

PRODUCT FEATURES:
Fast-drying
Indoor/Outdoor
Durable, corrosion-resistant

Scroll to bottom of page for color chart

This Item Can NOT Be Shipped Internationally


Item# Item Name List Price Our Price Qty Add
7785830 Rust-Oleum Stops Rust Cold Galvanizing Compound Spray
$10.09
$7.76
7785830-BOX Rust-Oleum Stops Rust Cold Galvanizing Compound Spray - (Box of 6) Save by the box: $7.28 ea
$60.54
$43.68
Check the items you wish to purchase, then click


Features:




Extended Information:
PAINTING CONDITIONS
Use outdoors or in a well ventilated area such as an open garage. Apply when temperature is between 50-90F (10-32C) and humidity is below 65% to ensure proper drying. Do not apply to surfaces, when heated, exceed 200F (93C). Avoid spraying in very windy and dusty conditions. Cover surrounding area to protect from spray mist.

SURFACE PREPARATION
Remove all dirt, grease, oil, salt and chemical contaminants by washing the surface with a commercial detergent, or other suitable cleaning method. Rinse with fresh water and allow to thoroughly dry. Remove loose paint and rust with a wire brush or sandpaper.

WARNING!
If you scrape, sand or remove old paint from any surface, you may release lead paint dust. LEAD IS TOXIC.
EXPOSURE TO LEAD DUST CAN CAUSE SERIOUS ILLNESS, SUCH AS BRAIN DAMAGE; ESPECIALLY IN
CHILDREN. PREGNANT WOMEN SHOULD ALSO AVOID EXPOSURE. Wear a NIOSH approved respirator
to control lead exposure. Clean up carefully with a HEPA vacuum and a wet mop. Before you start, find out how to
protect yourself and your family by contacting the National Lead Information Hotline at 1-800-424-LEAD or log on to
www.epa.gov/lead.

APPLICATION
Shake can vigorously for one minute after the mixing ball begins to rattle. If mixing ball fails to rattle DO NOT
STRIKE CAN. Contact Rust-Oleum. Shake often during use. Hold can upright10-16" from surface and spray in a
steady back-and-forth motion, slightly overlapping each stroke. Keep the can the same distance from the surface.
Keep the can in motion while spraying. Apply two or more light coats a few minutes apart to avoid drips and runs. Do
not use near open flame.

DRY & RECOAT
Dry and recoat times are based on 70F and 50% relative humidity. Allow more time at cooler temperatures. Dries to
touch in 15 minutes, to handle in 1-2 hours and fully dry in24 hours.If a topcoat is desired, use a latex coating.

CLEAN-UP
Clean valve immediately after use by turning can upside down and depressing spray button for 3-5 seconds.
Clean up wet paint with xylene or mineral spirits. Properly discard empty container. Do not burn or place in home
trash compactor.

CLOGGING
If the valve clogs, twist and pull off spray tip and rinse in a solvent such as mineral spirits. Do not insert any object
into can valve opening.




Share your knowledge of this product with other customers... Be the first to write a review

Browse for more products in the same category as this item:

Paint & Stains
Paint & Stains > Rust-Oleum > Stops Rust
Paint & Stains > Rust-Oleum