Auto Primers, 2067, 2081, and 2089 are fast drying and sandable for bare or lightly rusted surfaces. Auto Primers
can be used under auto touch-up paints but a test area is recommended for compatibility.
PAINTING CONDITIONS
Use outdoors or in a well ventilated area such as an open garage. Use when temperature is between 50-90°F
(10-32°C) and humidity is below 65% to ensure proper drying. Do not apply to surfaces, when heated, exceed 200°F
(93°C). Do not apply to galvanized steel. Avoid spraying in very windy and dusty conditions. Cover surrounding area
to protect from spray mist.
SURFACE PREPARATION
Remove all dirt, grease, oil, salt and chemical contaminants by washing the surface with a commercial
detergent, or other suitable cleaning method. Rinse with fresh water and allow to thoroughly dry. Remove loose
paint and rust with a wire brush or sandpaper. Previously coated surfaces must be sound and in good condition.
Smooth, hard, or glossy finishes should be scarified by sanding to create a surface profile.
WARNING! If you scrape, sand or remove old paint from any surface, you may release lead paint dust. LEAD IS TOXIC.
EXPOSURE TO LEAD DUST CAN CAUSE SERIOUS ILLNESS, SUCH AS BRAIN DAMAGE; ESPECIALLY IN
CHILDREN. PREGNANT WOMEN SHOULD ALSO AVOID EXPOSURE. Wear a NIOSH approved respirator
to control lead exposure. Clean up carefully with a HEPA vacuum and a wet mop. Before you start, find out how to
protect yourself and your family by contacting the National Lead Information Hotline at 1-800-424-LEAD or log on to
www.epa.gov/lead.
APPLICATION
Shake can vigorously for one minute after the mixing ball begins to rattle. If mixing ball fails to rattle DO NOT
STRIKE CAN. Contact Rust-Oleum. Shake often during use. Hold can upright 10-16" from surface and spray in a
steady back-and-forth motion, slightly overlapping eachstroke. Keep the can the same distance from the surface.
Keep the can in motion while spraying. Apply two or more light coats a few minutes apart to avoid drips and runs. Do
not use near open flame.
DRY & RECOAT
Dry and recoat times are based on 70°F (21°C) and 50% relative humidity. Allow more time at cooler temperatures.
Dries to touch in 15-30 minutes and dries to handle in 1-2 hours. Apply a topcoat or recoat within 1 hour or after 48
hours.
CLEAN-UP
Wipe off tip before storing. Clean-up wet paint with xylene or mineral spirits. Properly discard empty container. Do
not burn or place in home trash compactor.
CLOGGING
If the valve clogs, twist and pull off spray tip and rinse in a solvent such as mineral spirits. Do not insert any object
into can valve opening.
