Home > Paint & Stains > Rust-Oleum > Specialty >

Rust-Oleum Plastic Primer Spray

Rust-Oleum Plastic Primer Spray
Rust-Oleum Plastic Primer Spray


 
Rust-Oleum Specialty Plastic Primer Spray prepares plastic for painting with any top coat. Apply directly to plastic mailboxes, lawn chairs, storage lockers and more. Adheres to hard-to-paint surfaces.

PRODUCT FEATURES:
Adheres to hard-to-paint surfaces
Renew or change the color of plastic items around the home
Choose from a variety of top coat colors

This Item Can NOT Be Shipped Internationally


Item# Item Name List Price Our Price Qty Add
209460 Rust-Oleum Plastic Primer Spray White
$11.65
$9.74
209460-BOX Rust-Oleum Plastic Primer Spray White - (Box of 6) Save by the box: $9.17 ea
$69.90
$55.02
Check the items you wish to purchase, then click


Extended Information:
PAINTING CONDITIONS
Use outdoors or in a well ventilated area such as an open
garage. Use when temperature is between 50ºF (10ºC) and
90ºF (32ºC) and humidity is below 65% to ensure proper
drying. Avoid spraying in very windy and dusty conditions.
Cover surrounding area to protect from spray mist.

SURFACE PREPARATION
For new plastic surfaces, thoroughly wipe down surface with
paint thinner to promote adhesion. For aged or weathered
surfaces, remove loose material with a brush or scraper, clean
with soap and water, rinse and let dry. Sanding may be required
for glossy or smooth surfaces. If mildew is present, wash with a
bleach solution, rinse and let dry.

APPLICATION
Shake can vigorously for one minute after the mixing ball
begins to rattle. If mixing ball fails to rattle DO NOT STRIKE
CAN. Contact Rust-Oleum. Shake often during use. Hold can
upright 10-16” from surface and spray in a steady back-
and-forth motion, slightly overlapping each stroke. Keep the
can the same distance from the surface and in motion while
spraying. For best adhesion, apply one THIN coat and not a
heavy coat or multiple coats. Do not use near open flame.

DRY and RECOAT TIMES
Dry and recoat times are based on 70ºF and 50% relative
humidity. Allow more time at cooler temperatures. Dries to touch
in 20-30 minutes, to handle in 1 hour and fully dry in 24 hours.
Apply any Rust-Oleum finish coat after 1 hour. Maximum
adhesion is achieved in 5-7 days.

CLEAN-UP
When finished spraying, clear spray valve by turning the can
upside down and pushing the nozzle for 5 seconds. Clean-up
wet paint with xylene or mineral spirits. Properly discard empty
container. Do not burn or place in home trash compactor.

CLOGGING
If the valve clogs, twist and pull off spray tip and rinse in a solvent
such as mineral spirits. Do not insert any object into can valve
opening.




Share your knowledge of this product with other customers... Be the first to write a review

Browse for more products in the same category as this item:

Paint & Stains > Rust-Oleum > Specialty
Paint & Stains > Rust-Oleum
Paint & Stains