Rust-Oleum EPOXYShield Garage Floor Coating

Rust-Oleum EPOXYShield Garage Floor Coating

Rust-Oleum EPOXYShield Garage Floor Coating Gray Gloss

SKU: 203005

Each

Regular price $144.14 ea

Save by the box

Regular price $267.70 Box of 2 $133.85 ea
Rust-Oleum EPOXYShield Garage Floor Coating

Rust-Oleum EPOXYShield Garage Floor Coating Tan Gloss

SKU: 203006

Each

Regular price $144.14 ea

Save by the box

Regular price $267.70 Box of 2 $133.85 ea

Selected itemsItems: 0

Total: $0.00

Create an easy-to-clean showroom quality appearance with EPOXYShield Garage Floor Coating. It's water-based for low odor and easy clean-up. Water and chemical resistant - no hot tire pick-up. Kit includes concentrated surface cleaner and instructional video. Kit Content - Part A, Part B, concentrated cleaner, decorative color chips, stir stick, instruction sheet.

PRODUCT FEATURES:
Indoor use only
Gloss
Cleans with soap and water.

SURFACE PREPARATION
Allow new concrete to cure for a minimum of 28 days. Sweep
away all loose dirt and debris. Remove any oil spots, grease
or spills and wash the floor with a suitable detergent or
degreasing solution and rinse. Then etch the floor using the
Concrete Etch.
PREVIOUSLY COATED FLOORS: Make sure the floor is clean and dry.
Use a wire brush to remove any loose or peeling paint or stain. If floor is
sealed, the sealer will have to be removed by grinding or shot blasting.
To ensure proper adhesion, scuff sand the entire surface. WARNING! If
you scrape, sand or remove old paint, you may release lead dust. LEAD
IS TOXIC. EXPOSURE TO LEAD DUST CAN CAUSE SERIOUS ILLNESS
SUCH AS BRAIN DAMAGE, ESPECIALLY IN CHILDREN. PREGNANT
WOMEN SHOULD ALSO AVOID EXPOSURE. Wear a NIOSH-approved
respirator to control lead exposure. Clean up carefully with a HEPA
vacuum and a wet mop. Before you start, find out how to protect
yourself and your family by contacting the National Lead Information
Hotline at 1-800-424-LEAD or log on to www.epa.gov/lead.

MIXING
Premix both components (Parts A and B) thoroughly to ensure any
settled pigment is re-dispersed before adding the activator (Part A)
to the base (Part B). It is critical to add all of Part A to B and mix for
3 minutes. Do not mix the color chips in with the coating. Allow the
coating to stand before using. See induction period on page 2. Mix
again just prior to application. The activated coating must be used
within 1-2 hours after the mixing based on temperature.
APPLICATION
Apply only when air, material, and surface temperatures are
between 60-85°F (15-29°C) and the surface temperature is
at least 5°F (3°C) above the dew point. The relative humidity
should not be greater than 85%. After allowing for the induction
period, cut in the perimeter of the floor along the wall, or other
areas where a roller cannot reach, using a brush or edger before
beginning roller application. Use a synthetic ½” nap roller cover
on a 9” roller frame to apply an even coat of EPOXYShield
onto the surface. Limit the application to 4x4 foot (1.2x1.2m) sections
at a time to make it easier to distribute the colored chips onto the
freshly coated surface. Scatter the decorative chips up and away
from you so they land flat on the wet paint, then continue on to
the next section. Note: Fresh paint can be applied over the loose
chips lying outside the previously painted area. Maintain a wet
edge to prevent lap marks and gloss differences. Only one coat
is necessary under most circumstances. EPOXYShield must be
used within 1 to 2 hours of initial mixing.
CLEAN-UP
Wash tools and equipment with warm water and a mild detergent
immediately after use. To remove dried product use lacquer
thinner. Clean up drips or spatters IMMEDIATELY with water as
dried paint is very difficult to remove. Properly dispose of all soiled
rags.

Rust-Oleum EPOXYShield Garage Floor Coating

Selected itemsItems: 0

Total: $0.00

**Important Note** - You have selected a special order item that requires an extended shipping time. Also note, we cannot verify in stock status until we receive a shipping confirmation from the manufacturer as their stock is constantly changing. All sales are final on special order items, once ordered no changes, cancellations, returns, or refunds can be made, order carefully. By clicking OK below you acknowledge this exception.