Extended Information:
Surface Preparation: Surface must be free from grease and other residues, dry, smooth and structurally sound. Check surfaces for paint bonding, loose wallcoverings, damaged wall- board or plaster. Repair all unsound surfaces. Prime all surfaces (including oil-based coatings) with ROMANŽ PRO-977, ULTRA PRIMEŽ. Priming of bare drywall is not required with fabric-backed wall coverings. Before proceeding with any unusual conditions, consult your adhesive or wallcovering supplier.
Dilution: To use with pre-pasted wallcoverings, dilute with 1/2 gallon of clean water per gallon of adhesive. For some pasting machines, thin with maximum of one pint of clean water per gallon. Application Method:
Use only when the room temperature is above 50°F. Apply an even coat of adhesive with a pasting machine, brush, or roller. Avoid contact with the surface of embossed, textured or delicate wallcoverings. Book wallcovering according to the wallcovering manufacturerʼs instructions. Drying Time:
Varies, depending on the temperature, ventilation, and humidity of the room. Clean-Up:
Before the adhesive dries, remove any excess with clean water. Additional effort may be required if the adhesive is allowed to contact the surface of embossed or textured vinyls. WARNING--Roman Decorating Products LLC
does not endorse the use of any product in an installation that does not meet a Class A fire rating or any applicable code. Testing by a certified laboratory should be conducted to verify the installation meets a Class A fire rating and to guarantee compliance with all applicable codes. Specifically, if a Roman product is to hang wallpaper over existing wallpaper, it is unlikely to meet these standards.
|