(Your shopping cart is empty)

Note: Not live rates
For reference purposes only
All sales in US Dollars

Join our mailing list!

  Home > Seal Krete >

Seal-Krete 1/2 Gal Concrete Clean-N-Etch 411000
Seal-Krete 1 Gal Concrete Clean-N-Etch 411000
Seal-Krete 1 Gal Concrete Clean-N-Etch 411000

Seal-Krete Concrete Clean-N-Etch neutralizes new concrete and removes new / light rust stains from concrete, steel, and other masonry surfaces. Suitable for interior / exterior use. Clean-N-Etch is biodegradable and safe to use near grass and plants. Use Clean-N-Etch on bare concrete, garage floors, basements, driveways, carports, patios, walkways and pool decks.

Item# Item Name List Price Our Price Qty Add
41100-1 Seal-Krete 1/2 Gal Concrete Clean-N-Etch 411000
41100-1BOX Seal-Krete 1/2 Gal Concrete Clean-N-Etch 411000 - (Box of 4)
Save by the box: $11.77 ea
Check the items you wish to purchase, then click

Extended Information:
Etching solution used to clean and degrease
bare concrete surfaces to improve penetration and
adhesion of paint, stains and sealants; self-neutralizing,
environmentally safe, no odor and no VOCs.

Typical Uses:
Garage fl oors
Pool Decks

Read all instructions thoroughly. Wear safety
goggles with side shields, rubber gloves and protective

Sweep surface. Use a degreaser like SEAL-
KRETE® Oil Stain Remover to remove oily stains. For best
results, pressure-wash surface prior to etching.

For garage floors and other smooth-troweled
concrete, mix 1/2 gallon of Clean-N-Etch to 1/2 gallon of
water. For other surfaces, mix 1/2 gallon of Clean-N-Etch to
1 gallon of water. For light cleaning, mix 1/2 gallon of Clean-
N-Etch to 1-1/2 gallons of water.

Read “LIMITATIONS” section before use.
Working a 10 ft. x 10 ft. section at a time, dampen surface
with water, then apply Clean-N-Etch with a pump sprayer
or watering can. Using a stiff-bristled broom, scrub solution
into surface until foaming action stops. Rinse surface
thoroughly with a strong stream of water, scrubbing while
rinsing to ensure removal of all material. Surface should feel
rough (like 150 grit sandpaper). When dry, check surface
by applying a few drops of water. Water should penetrate
quickly – if not, re-etch affected area. Allow surface to dry
thoroughly before applying paint or stain.
Note: Smooth
troweled concrete (i.e., carports, garage and basement
floors) generally requires 2 applications to achieve a proper

Clean all application tools with
water immediately after use. KEEP FROM FREEZING. Always
store at temperatures above 50°F.

Do not apply to concrete that has already been sealed, painted or stained.

Share your knowledge of this product with other customers... Be the first to write a review

Browse for more products in the same category as this item:

Seal Krete