PC Concrete epoxy gel is an anchoring and concrete repair product. PC Concrete is formulated for anchoring threaded rods, bolts, rebar dowels and smooth dowels into concrete, grout filled block, and unreinforced masonry. PC Concrete has exceptional strength, maximum field reliability, along with a high heat deflection temperature of 134°F, which provides engineers and contractors with a choice for specifying and setting adhesive anchors in elevated temperature environments.|
PC Concrete is excellent for filling and repair cracks in concrete. PC Concrete™ out performs all caulks and hydraulic cement. PC Concrete will not come loose from any cleaned concrete surface. PC Concrete™ will hold during expansion and contraction of concrete. PC Concrete™ the best solution for permanent concrete repair.
PC Concrete is a two component (1:1 ratio), 100% solids, high modulus, and structural epoxy gel. It is a solvent free, no odor, high strength, moisture-insensitive epoxy. In addition, PC Concrete™ has a long working time (20 minutes at 75°F.), while providing a bolt down/paint time in as little as 4 hours.
Job site preparation and work flow – to achieve the desired results, carefully follow these procedures!
**Always be sure the hole/crack is prepared in advance before starting a new cartridge. If at all possible, schedule dispensing to consume an entire cartridge at one time with no interruption of epoxy flow.
To achieve maximum flow and reduce fatigue, break off the nozzle to the largest diameter that will fit into the hole/crack or screen. If the hole is 5/8” diameter or larger, snap off the smaller diameter section before using.
Most nozzles snap off to accommodate varying hole diameters and depths.
After cure: Paint, Drill, Machine, Sand, File, Tap, or Saw.