PC-7 Epoxy
PC-7 Epoxy 2 Oz 02777 SKU: 02777-1 |
Each
Regular price
$6.22 ea
|
Save by the box
Regular price
$70.20 Box of 12
$5.85 ea
|
|
PC-7 Epoxy .5lb SKU: 08777-1 |
Each
Regular price
$13.92 ea
|
Save by the box
Regular price
$157.20 Box of 12
$13.10 ea
|
|
PC-7 Epoxy 1lb SKU: 16777-1 |
Each
Regular price
$21.08 ea
|
Save by the box
Regular price
$221.64 Box of 12
$18.47 ea
|
|
PC-7 Epoxy 4lb SKU: 64777-1 |
Each
Regular price
$63.61 ea
|
Save by the box
Regular price
$118.86 Box of 2
$59.43 ea
|
|
PC-7 Epoxy 8lb 1G SKU: 12877-1 |
Each
Regular price
$111.63 ea
|
Save by the box
Regular price
$212.98 Box of 2
$106.49 ea
|
|
PC-7 Epoxy 90 lb SKU: 90907-1 |
Each
Regular price
$776.75 ea
|
PC-7® is the tough job epoxy! This paste epoxy was formulated for maximum bonding power. When mixed, components A (grey) and B (black) reacts to form a bond of tremendous strength. PC-7® formulation provides extended working time, for large and critical jobs, which allow the user to reposition work or make changes. High “wet grab” or tack of PC-7® Paste Epoxy makes overhead and sidewall work easy without drip or sag. PC-7® demonstrates excellent chemical resistance to mild acids, caustics, detergents, gasoline, fuel oil, salt, and fresh water.
***Note: PC-7® will not bond to wax paper, Teflon®, Polyethylene, and some other plastics. There are hundreds of plastics in thousands of combination. Test a small area when in
Directions:
Using separate knives to remove amount needed, mix equal parts A (grey) and B (black) on flat clean surface until uniform color is achieved. Surfaces to be bonded must be free of dirt, oil, rust, etc. For best results, rough up the surface PC-7® will be bonding to. Normally, no vice or clamp needed. Prop or tape heavy objects to a wall or ceiling.
Apply PC-7® Epoxy Paste in any thickness to both sides of surface and bring together firmly. Be careful to insure that ample amount of PC-7® remains between the contact surfaces. Use screen wire or fiberglass cloth to reinforce large voids and gaps.
Denatured alcohol is excellent for smoothing applied PC-7®. Also use Denatured alcohol to clean surfaces before applying.
After cure: Paint Drill, Machine, Sand, File, Tap, or Saw.