Loctite Super Glue Ultra Gel Control is a rubber toughened formula that resists impact, shock, vibration and extreme temperatures. It is ideal for bonds that are subject to daily use and harsh conditions. It is Outdoor Safe and gives more time to align pieces before the glue takes hold. The patented side squeeze design allows for maximum control and air-tight storage. Dries clear and sets without clamping. Loctite Super Glue Ultra Control Gel is resistant to moisture and freezing temperatures. Recommended for use when repairing figurines, metal car parts, costume jewelry, cameras, wiper blades, toys, rubber seals and O-Rings. Bonds leather, cork, paper, cardboard, wood, chipboard, fabric, metal, ceramic, rubber and hard plastics such as Plexiglas®, polycarbonate, polystyrene and PVC. Ideal for vertical surfaces and for applications requiring flexibility. No mess, no drip formula. Dries transparent for invisible repairs. Sets in seconds so no clamping is required. 4 gram bottle. |
Not recommended for use in diswashers, ovens, or microwaves or bonding assemblies that will hold hot liquids. Not for use on Polyethylene, polypropylene, polytetrafluoroethylene (PTFE)/Teflon®, silicone rubber, polystyrene foams or glass.
Tools Typically Required:
Wear gloves. Protect work area.
Surfaces to be bonded must be close fitting, clean, dry and free from oil, wax and paint. For best results, lightly roughen smooth surfaces. Pre-fit parts to be joined.
To puncture the nozzle, screw the cap clockwise continuously into the
base until the clicking sound stops. Unscrew the cap counter clockwise
to open the bottle. Squeeze the blue side grips to dispense the adhesive.
Only one drop of adhesive per square inch of surface is required.
Press surfaces together immediately and hold for 15-30 seconds. Do not
attempt to reposition the parts. Immediately after use, clean tip with
tissue and replace cap. For increased strength, leave the parts undisturbed
for at least 10 minutes. Full cure in 24 hours. Note: Cure time is dependent upon temperature, humidity, porosity of surfaces and amount of adhesive applied.
After cleaning, wet any tissue used for wiping off glue with water and
dispose of. When cleaning up larger quantities of uncured adhesive,
apply water and allow to cure and then scrape up. Note this may result in
damage to the surfaces. Cured adhesive may be cut away with caution using a sharp blade, removed with acetone or with boiling water. Note:
Acetone is highly flammable and may not be suitable for use on all materials, test surface first. Follow manufacturer’s instructions.
Storage and Disposal:
Not damaged by freezing in the unopened container. Optimal shelf life
is achieved when unopened container is stored from 36°F to 46°F (2°C to 8°C). After opening, it is not recommended that the product be
stored cold or frozen. Once opened, the product is best stored tightly
sealed in a dry location away from heat sources or sun exposure. Humidity and
high temperatures may decrease shelf life. Use an approved hazardous waste facility for disposal.