Home > Krud Kutter >

Krud Kutter Concrete Clean & Etch

Krud Kutter Concrete Clean & Etch
Krud Kutter Concrete Clean & Etch


 
Cleans & Prepares Concrete, Masonry & Brick for Coating, Staining or Sealing. Ideal for cleaning, degreasing, and acid etching concrete floors, walls, basements, driveways, swimming pools, patios, and containment areas prior to coating, staining or sealing.
Safer and easier to use that muriatic acid, it creates a porous surface, and provides the even profile and uniform appearance preferred for clear coating applications. Also removes efflorescence (alkali salts) and neutralizes new concrete and new mortar joints.
Earth Friendly: Water-Based . Biodegradable . Ordorless . Non-Flammable . Environmentally Responsible


Item# Item Name List Price Our Price Qty Add
CE32-1 Krud Kutter Concrete Clean & Etch 32oz
$14.91
$12.00
CE32-BOX Krud Kutter Concrete Clean & Etch 32oz - (Box of 6)
Save by the box: $11.26 ea
$89.44
$67.56
CE01-1 Krud Kutter Concrete Clean & Etch Gallon
$34.61
$24.02
(Out of Stock)
CE01-BOX Krud Kutter Concrete Clean & Etch Gallon - (Box of 6)
Save by the box: $22.52 ea
$207.63
$135.12
(Out of Stock)
Check the items you wish to purchase, then click


Technical Specs:
CAUTION
Eye and skin irritant. In case of contact with eyes or skin, flush with water for 15 minutes. If irritation persists, seek medical attention. If swallowed, take large amounts of water. Do not induce vomiting. Get medical attention.
DO NOT MIX THIS PRODUCT WITH ANY OTHER CHEMICALS.
KEEP OUT OF REACH OF CHILDREN.
CONTAINS: Phosphoric acid in a water-based solution.
NO MURIATIC ACID!




Extended Information:
Directions for use:
1. Mix 1/3 gallon (43 oz.) of concentrate with 1 gallon of water in a plastic sprinkling can. One gallon of concentrate will produce 4 gallons of premix; sufficient to cover 800 square feet. Hot water will accelerate cleaning and etching.
2. Sweep the surface to remove loose debris, and scrape off excess grease and oil.
3. Cleaning a 10’ x 10’ section at a time, dampen the surface with a fine spray of water, and using the sprinkling can, apply the premix evenly over the surface.
4. Scrub the premix into the surface with a stiff bristled broom until the foaming stops. NOTE: If no foaming occurs, surface has been previously sealed and this will prevent penetration of premix. Remove the sealer and reapply KRUD KUTTER CONCRETE CLEAN & ETCH premix.
5. Triple rinse the surface with a water hose. Scrub while rinsing to ensure removal of all loosened material.
6. Allow the surface to dry thoroughly before applying stain or sealant.
7. After the surface has dried, check any glossy or oily areas by applying a few drops of water. If water does not penetrate quickly, re-etch the affected areas.
COVERAGE: 200sq.ft./quart; 800sq.ft./gallon





Share your knowledge of this product with other customers... Be the first to write a review

Browse for more products in the same category as this item:

Krud Kutter
Green Products > Green Cleaners
Cleaning Products > Surface Cleaners & Degreasers
Cleaning Products
Green Products