M-1 now takes up where other additives leave off. M-1 Advanced Mildewcide provides the broad-spectrum fungicidal capability other additives cannot, without hurting the environment. Our new cutting edge biocide carrier is non-toxic and does not contribute to the odor or VOC of paint.|
M-1 Advanced Mildewcide is compatible with virtually every available aqueous and non-aqueous paint formulation tested, making it both versatile and cost effective.
For Use in All Interior/Exterior Latex, Water Based, Oil & Solvent Based Paints, Stains, Coatings and Adhesives
No Odor/Low VOC.
Do not apply this product in a way that will contact any person or pet. Causes skin irritation and moderate eye irritation. Avoid contact with eyes, skin and clothing. Harmful if swallowed, inhaled or absorbed through the skin. Wash thoroughly with soap and water after handling. Users should wash hands before eating, drinking, chewing gum, using tobacco or using the toilet. Remove contaminated clothing and wash before reuse.
IF IN EYES: Hold eye open and rinse slowly and gently with water for 15-20 minutes. Remove contact lenses, if present, after first 5 minutes, then continue rinsing eye. Call a poison control center or doctor for treatment advice.
IF ON SKIN OR CLOTHING: Take off contaminated clothing. Rinse skin immediately with plenty of water for 15-20 minutes. Call a poison control center or doctor for treatment advice.
IF SWALLOWED: Call a poison control center or doctor immediately for treatment advice. Have person sip a glass of water if able to swallow. Do not induce vomiting unless told to do so by the poison control center or the doctor. Do not give anything by mouth to an unconscious person.
IF INHALED: Move person to fresh air. If person is not breathing, call 911 or an ambulance, then give artificial respiration, preferably mouth-to-mouth, if possible. Call a poison control center or doctor for further treatment advice.
Have the product container or label with you when calling a poison control
center or doctor, or going for treatment.
EMERGENCY MEDICAL INFORMATION (800) 900-4044
NOTE: Read precautionary statements prior to handling the product.
Add M-1 Advanced Mildewcide as directed below to the coating for maximum protection against mold, mildew, and algae.
Mix thoroughly, stirring M-1 Advanced Mildewcide into the coating for 2-3 minutes. Apply the coating to the surface as directed by the coating manufacturer. In all cases, the coating should be mixed prior to applying to the surface. To ensure best results, follow coating manufacturer's instructions for cleaning and preparing the surface. M-1 Advanced Mildewcide is for protecting the applied film and paint, not the substrate.
Pour entire contents into 5 gallons of paint or other coating. Shake or stir thoroughly for 2-3 minutes.
This pesticide is toxic to fish and aquatic organisms. Do not apply directly to water. Do not contaminate water when disposing of equipment, washwaters or rinsate.
STORAGE AND DISPOSAL
Do not contaminate water, food, or feed by storage or disposal. PESTICIDE STORAGE: Do not store with strong oxidizing agents or strong (concentrated) acids. Keep container tightly closed when not in use. Do not reuse container. PESTICIDE DISPOSAL: Wrap empty container and paint stirrer in newspaper and dispose immediately in trash. Never place unused product down any indoor or outdoor drain.