PREP: Wire brush or sand scaling paint, dirt, loose or heavily rusted
area. Use paint thinner for oil and grease removal.
APPLICATION: Wear chemical-resistant gloves and chemical splash
goggles. Apply Prep & Primer directly to metal by brush, roller,
mop, or low pressure spray. Heavy rust may need two applications.
FINISH - RUSTED AND OLD METAL: Wait overnight after application of
Prep and Primer, dust off any loose powder, apply undercoat primer and
paint. GALVANIZED: Paint can be applied when Prep and Primer is
thoroughly rinsed within 30–60 minutes, and dried.
CLEANUP: Clean application equipment with water.
COVERAGE: Approximately 150 sq.ft. per quart.
HELPFUL TIPS: Test small area for compatibility when using epoxy or
latex paint. Follow paint manufacturers instructions for undercoats and
top coats. Protect plants, concrete, masonry and paint from overspray
and flush immediately with water if contact is made. Do not use an
airless sprayer or dilute this product. Do not use when temperature is
below 36º F.