Home > Paint & Stains > Insl-x Coatings >

Insl-x ODOR LESS Primer/Sealer

Insl-x ODOR LESS Primer/Sealer
Insl-x ODOR LESS Primer/Sealer


 
A fast drying, white pigmented coating that both primes and seals plaster, wood, drywall and masonry.  Developed as a low odor, solvent base primer; Insl-x ODOR LESS Primer provides excellent enamel hold-out, will not raise wood grain; and is a high performance reactive stain blocker that seals stains from smoke damage; bleed-through from wood knots, crayon, lipstick, etc. Can be topcoated with any latex or alkyd finish coat. The fast dry characteristics allow for same day top coating and the low odor makes it an excellent choice for use as a stain blocking primer in occupied buildings.



Extended Information:
Surface Preparation The surface to be painted must be clean, dry and free of dirt, wax, grease, rust, mildew, loose and peeling paint and all other contamination. Dirt, wax and chalk should be removed using a detergent solution. Scrub stained area vigorously to remove as much of the stain as possible. Mildew should be removed by washing with a solution of one part household bleach* and three parts water. Rinse well and allow it to dry. Grease and oil should be removed using an Oil and Grease Emulsifier. Loose or peeling paint should be scraped or sanded and any remaining tightly adhering paint should be sanded to a featheredge. Remove sanding dust with a tack rag. Loose wallpaper and any residual paste should be removed by scraping, sanding or using a commercial wallpaper remover. *Follow bleach manufacturer’s instructions for safe handling and use of bleach solution.

WARNING! If you scrape, sand or remove old paint, you may release lead dust. LEAD IS TOXIC. EXPOSURE TO LEAD DUST CAN CAUSE SERIOUS ILLNESS, SUCH AS BRAIN DAMAGE, ESPECIALLY IN CHILDREN. PREGNANT WOMEN SHOULD ALSO AVOID EXPOSURE. Wear a NIOSH-approved respirator to control lead exposure. Carefully clean up with a HEPA vacuum and a wet mop. Before you start, find out how to protect yourself and your family by contacting the National Lead Information Hotline at 1-800-424-LEAD or log on to www.epa.gov/lead.

Application - Stir product thoroughly before application. Odor Less Primer can be applied by brush, roller, pad or spray. When applying by roller, let the texture of the surface determine the depth of nap. When brushing, use either a natural bristle brush or one with a nylon/polyester filament recommended for use with solvent based products. If applying by airless sprayer use a tip size .013 -.015. Do not apply Odor Less Primer unless the surface, material and ambient temperatures are 45º F or over. Do not paint if surface temperature is within 5 degrees of the dew point.  NOTE: For best results, apply finish coat within 48 hours.   

Cleanup - Clean tools with mineral spirits immediately after use. Clean spills quickly with mineral spirits. Dried material is difficult to remove.  DANGER – Rags, steel wool or waste soaked with the product may spontaneously catch fire if improperly discarded. Immediately after use, place rags, steel wool or waste in a sealed water-filled metal container. USE COMPLETELY OR DISPOSE OF PROPERLY.   This product contains organic solvents which may cause adverse effects to the environment if handled improperly.  Emptied containers may retain product residue. Follow label warnings even after container is emptied. Residual vapors may explode on ignition. Disposal of wastes containing either organic solvents or free-liquids in landfills is prohibited. Local disposal requirements vary; consult your sanitation department or state-designated environmental agency for local disposal options.


Share your knowledge of this product with other customers... Be the first to write a review

Browse for more products in the same category as this item:

Paint & Stains > Insl-x Coatings
Paint & Stains