Home > Paint & Stains > Hammerite Paint and Spray Paint >

Hammerite Rust Cap Hammered Enamel Finish Spray

Hammerite Rust Cap Hammered Enamel Finish is a self-priming, rust preventive coating designed to provide long-lasting metal protection. It provides a decorative finish that resists corrosion and the damaging effects from moisture and severe weather. Formulated for interior and exterior use. * For use on metal substrates. * Can be applied directly over firm, rusty surfaces. * For previously painted surfaces, apply Hammerite Rust Cap Hammered Enamel Finish to a small area first to check adhesion and test for lifting or cracking.
Please note that the manufacturer is discontinuing the entire line of Hammerite products. Therefore, we can NOT guarantee shipping of the product as it is only available while supplies last.

Item#	Item Name	List Price	Our Price	Qty	Add
41120-BOX	Hammerite Rust Cap Hammered Enamel Finish Spray 12oz Brown - (Box of 6) Save by the box: $8.45 ea	$70.38	$50.70	(Out of Stock)
Check the items you wish to purchase, then click

Features:

The colors that appear on the screen and in print may not match actual applied color.

Extended Information:

Surface Preparation

Prepare surface by removing dirt, grease, wax, moisture, rust, loose paint and any other contamination that can affect the coating's adhesion. If washing is necessary, use a non-soapy detergent or TSP substitute. Rinse well and allow to dry.
Scrape off loose paint and rust with a wire brush.
Scuff sand rusted, glossy or hard surfaces.

Aerosol Application

Use outdoors, or in a well-ventilated area when temperature is between 60°F and 80°F and humidity is below 60% to ensure proper drying. Avoid spraying in very windy or dusty conditions.
Shake can vigorously for 2 minutes after mixing ball begins to rattle and often during use. Hold can upright, moving from side-to-side while spraying lightly and evenly about 12” from area being painted. Ensure corners, edges and heavily pitted areas are adequately covered. Apply 3 or more light coats allowing 10 to 15 minutes between coats.

Aerosol Dry Time & Coverage

Dries in 15 minutes or less.
Handle after one hour.
Recoat should be done within 1 hour or after 10 days.
A 4 mil coating cures in 14 days.
Coverage up to 18 sq. ft.

Aerosol Clean Up & Disposal

Clear spray valve immediately after use by turning can upside down and spraying until only clear gas is released.
If spray nozzle becomes clogged, remove and clean with mineral spirits. Gently replace spray button with a twisting motion, with top of can and valve opening pointed away from you. Do not stick pins or wire into can opening.
Do not dispose of this product down a drain.
Please consider donating any unused product.
For recycling or disposal information, contact your local household refuse collection service.

Share your knowledge of this product with other customers... Be the first to write a review

Browse for more products in the same category as this item:

Paint & Stains > Hammerite Paint and Spray Paint
Paint & Stains