Shake well before using. Spray wood with water, then apply
Stripper with a brush or roller. Use synthetic brushes or rollers only.
Wood Stripper’s thick formula may be used on vertical surfaces.
To maintain product effectiveness,
with water. Allow Stripper to stay wet on surface
approximately 15-45 minutes to remove coating.
Difficult areas may take longer. Wood Stripper
becomes extremely slippery once applied. Work on
surface. Test a small area to determine the time
required for product to strip effectively.
Test a small area by scrubbing with a bristle brush to
determine if the coating is easily removed and the
surface is ready for rinsing. When ready, scrub the
surface with a firm bristle brush or long handled push
broom. Rinse thoroughly with water using a garden
hose or pressure washer. Do not exceed 1000 PSI
when using a pressure washer. Rinse any residue
Wood species such as redwood, cedar and fir will
tend to darken after being stripped. Use Superdeck®
Wood Brightener as the final step to brighten the
wood and neutralize the surface before coating.
Apply product at temperatures above 50° F. and
below 90° F. Do not apply in direct sunlight if
possible. Protect any aluminum surfaces (such as
window frames) to prevent discoloration. Product will
etch metal. If product makes contact with glass, rinse
thoroughly before it dries. Mist any nearby
vegetation with water before and after application.
100-200 sq. ft. per gallon
Clean all tools with water.
SAFE USE & STORAGE:
When using, do not eat, drink or smoke. Wash hands
after use and before eating, drinking or smoking.
Product is corrosive, avoid contact with metals such
as aluminum. Do not transfer contents into a metal
container or unlabeled container. Store in well
ventilated area. Keep container tightly closed when
not in use. Protect from freezing. For exterior use