The colors that appear on the screen and in print may not match actual applied color.
All surfaces must be clean, dry, and free from dirt,
mildew stains, dust and other foreign matter. Do not
apply over sealed surfaces. For wood surfaces
remove surface stains, dirt and failed oxidized
stains with SuperdeckÂ® Wood Cleaner. Remove all loose
peeling paint, rinse thoroughly with water and allow
to completely dry before coating. For concrete
surfaces do not apply to smooth concrete, use
Masonâs SelectÂ® Concrete Etcher and follow
instructions for etching concrete surfaces.
If you scrape, sand or remove old paint, you may
release lead dust.
LEAD IS TOXIC. EXPOSURE TO LEAD
DUST CAN CAUSE SERIOUS ILLNESS, SUCH
AS BRAIN DAMAGE, ESPECIALLY IN CHILDREN. PREGNANT
WOMEN SHOULD ALSO AVOID EXPOSURE. Wear a
NIOSHâapproved respirator to control lead
exposure. Clean up carefully with a HEPA Vacuum and wet mop.
Before you start, find out how to protect yourself and
your family by contacting the National Lead Information Hotline
at 1-800-424-LEAD or log on to www.epa.gov/lead.
Shake well or stir thoroughly from bottom to top of
container and occasionally during application. When
using more than one container of product, intermix
all containers to ensure color consistency. Test small
area first for color satisfaction.
Do not thin.
Apply a thick coat with brush, roller, or airless sprayer. When
rolling use 3/8â nap synthetic roller cover for smooth finishes, 1/2â
-3/4â nap for medium texture finish, and 1-1/4â nap for heavy texture
finishes. Back rolling is suggested when spraying working the
product smoothly and evenly into the su rface to ensure a uniform appearance.
Always maintain a wet edge to avoid lapping.
Test Area: Always apply product to a small test
area and allow to dry completely before coating entire project to
ensure desired color and appearance.
Use DuckbackÂ® Anti-Skid Additive to create a slip
resistant surface on patios, sidewalks, ramps, stairs,
poolsides and other areas that require a slip resistant
surface. Just add 1 pack of Anti-Skid per gallon to final
coat of Deck & Dock, stir well and apply with a roller.
Meets ADA slip resistant standards when used with
Deck & Dock.
50Â° F-90Â° F. Do not apply product in extreme heat of
day or if surface is hot to touch. Do not apply product
if rain is likely to occur within 24 hours.
DRY TIME @ 77Â° F:
1 Hour to touch. Allow surface to dry until it can be
lightly walked on (2-4 hours) before recoating. Once
the final coat has been applied allow 24-48 hours dry
time for normal foot traffic. Dry time may be prolonged
in cooler temperatures or high humidity.
Surface may remain tacky until fully dried and cured.
Avoid using surface until fully dry. Due to the
elastomeric nature and high build of this product, full
dry and cure time may take a few days.
Coverage may vary on surface condition, type of
surface and number of coats applied. On most wood
and concrete surfaces the coverage will be about 100
square feet per gallon for application of 1-2 coats.
When filling deep cracks in concrete or locking down
splinters on old extremely damaged wood surfaces
additional coats may be needed.
Apply one new coat of Deck & Dock every 5-7 years
to a clean surface to renew color and maintain
durability. Use SuperdeckÂ® Wood Cleaner and follow
maintenance instructions before recoating.
Clean brushes and equipment with soap and water.
Dispose of empty container or unused portion in
accordance with local, state, and federal regulations.