Deft Clear Wood Finish Brushing Lacquer

America's finest brushing lacquer gives a deep rich appearance to interior wood surfaces including, furniture, cabinets, molding, antiques and crafts.

• Dries in 30 minutes recoat two hours
  * No need to sand between coats
  * Dries crystal clear
  * Self leveling formula means no brush marks
  * Easy touch up - new coat melts into previous coats
  * Resists water, alcohol, and other common household spills
  * Convenient aerosol can with adjustable spray valve

NOTE:  This item has been discontinued and is now being manufactured under the PPG ProLuxe label as ProLuxe Interior Brushing Lacquer Clear Wood Finish

Saves Time & Labor
*Applies easily with a brush, pad or roller.
*Won't leave brush marks.
*Self-leveling formula requires no sanding between coats.
*Dries Crystal clear and 5-times faster than polyurethane.
*Fast Drying and easy application makes 1-day finishing possible.
*Easy to touch-up

Beautiful & Durable
*Delivers the professional look of fine furniture.
*Crystal clear finish resist yellowing over time.
*Enriches finished or unfinished wood.
*Beautiful protection of indoor wood, brass and silver.
*Resist Alcohol, fruit juice, water and other common household spills.

Application: Wear rubber gloves while working with any stain or finish products. If staining, note dry time or stain label before finishing.

Finishing unfinished wood:
1. Sand wood with 180 grit sandpaper to proper smoothness, remove dust, and stain if desired.
2. Apply one even coat of Deft Lacquer Sanding Sealer with a bristle brush, orpad. Let dry for 1 hour. fine sand with the grain. Remove dust.
3. Apply the first even coat of Deft Clear Wood Finish with a brush, roller, or with Deft's Aerosol Spray. Do not thin.
4. Apply additional  coats at two hour intervals - numbe rof coats depends on the type of wood (open grain woods require more coats than closed grain) and kind off finish desired.
5. Three full coats provide a resistan ftinish. Where wood is exposed to water, apply an additional three coats.
6. Sand lightley after first coat with 220 grit sandpaper and dust with a dry brush.
7. For a hand-rubbed finish, rub the final coat lightly with 4/0 steel wool or a rubbing compound.
8. Clean brushes with laquer thinner. For temporary storage with out cleaning, tightly wrap brushes in Saran - Type material.