Surface Preparation & Application:
Surface must be clean, dry and free of
Stir thoroughly before use.
Apply with a clean putty knife.
One application is usually sufficient for
small repairs. For repairs deeper than
1/4, apply two or more layers allowing
spackling to dry between applications.
For a smoother finish, dip putty knife
in water and lightly smooth spackling.
Spackling will change color to white when
surface can accept a second application or
is ready to be painted or sanded in 1 to 5 hours.
Wet sanding is recommended to avoid generation
Clean tools immediately with water.
NOTE: To retain the effectiveness of
the dry time indicator, keep the
container tightly closed after use.
For Best Results:
Do not apply when temperatures are below 50°F.
Do not apply outside if rain is expected within 24 hours.
Do not use on floors or as a caulk, sealant or joint
filler over cracks and joints where expansion and
contraction may occur.
DO NOT USE AS A SKIM COAT.
For exterior applications, always topcoat with a good
quality exterior grade paint.
If a textured finish is desired, add clean sand to
spackling compound prior to application.
Do not use for tuck pointing applications on brick
For larger areas to be patched on bare concrete,
use a latex fortified Portland cement-based dry mix.
Wash tools immediately after use with water. Be sure
container lid is closed and tightly sealed. Store in a cool,