Cabot Semi-Solid Deck & Siding Stains are deep penetrating linseed oil-based stains that provide long lasting beauty and wood protection, highlight the natural beauty of the wood's texture with a uniquely pigmented appearance. With their extra pigmentation, Cabot deck and siding stains are extremely durable and help protect wood against the sun's damaging ultraviolet rays.|
Cabot Semi-Solid Deck & Siding Stains are ideal for use on wood where hiding coverage is desired, yet penetrating wood protection is needed. They also provide an outstanding value as a one-coat finish for recoating previously semi-transparent-stained surfaces. Cabot Semi-Solid Deck & Siding Stains can be used on most types of smooth and rough exterior wood, including decks, siding, fences, log homes and roofs. They provide excellent results on weathered wood and well-seasoned lumber such as cedar, fir, pine, cypress, spruce, redwood and plywood panel siding.
Spread rates will vary depending on the porosity of the surface. On smooth surfaces, 1400 series covers approximately 400-500 square feet per gallon, 17400 series covers approximately 250-350 square feet per gallon.
Proper surface preparation is the key to maximum stain performance. The durability of this product can be impaired by an unsound or poorly prepared surface. It is very important that the surface be clean of all dirt, mildew stains, loose wood fibers and other foreign matter. In order to be effective, a stain must be able to penetrate. Surfaces must be structurally sound and absolutely dry. (Moisture content must be below 15%, or wood must be exposed to dry weather a minimum of 3 to 5 days.) Previously semi-transparent stained or weathered wood surfaces must be either sanded, scrubbed with a detergent solution or Cabot Problem-SolverŽ Wood Cleaner and a stiff bristle brush, or power washed to remove the surface layer of all loose wood fibers, dirt, mildew stains, chalky residue and other foreign matter. Use Cabot Problem-Solver Strippers (8004) to safely remove all stains and paints from wood surfaces. Use Cabot Problem-Solver Wood Brightener to easily remove nail and metal rust stains and renew the wood's appearance. New smooth wood that is unseasoned or appears shiny should be allowed to weather sufficiently before staining, but generally no longer than three months.
Stir thoroughly before and occasionally while using. If the job requires more than one batch, blend them together. Apply evenly with a brush to small sections. For best results, use a high-quality pad applicator or stain brush. To avoid lap marks, start at one edge and follow through to the end of the boards. Restain depending on sun exposure and wear every 2-4 years (up to 1 year for Clear).
Before drying, clean brushes and equipment with soap and water. Use mineral spirits after drying.
Dispose of empty cans or unused portion in accordance with local, state and federal regulations. Close container when not in use. Danger: Rags, steel wool or waste soaked with this product may spontaneously catch fire if improperly discarded. Immediately after each use, place rags, steel wool or waste in a sealed, water-filled metal container. Dispose of according to local regulations.