Rust-Oleum Professional Primer Spray

Description

Rust-Oleum Professional Primer Spray provides twice the protection of enamels alone. Apply to metal, wood, concrete and masonry in heavy-duty and commercial environments. Protects against the elements.

PRODUCT FEATURES:
Fast-drying
Indoor/Outdoor
Durable, corrosion-resistant
Apply to clean or rusted surfaces.

This Item Can NOT Be Shipped Internationally

Extended Information

SURFACE PREPARATION

ALL SURFACES: Remove all dirt, grease, oil, salt and

chemical contaminants by washing the surface with a

commercial detergent,or other suitable cleaning method.

Mold and mildew must be cleaned with a chlorinated

cleaner or bleach solution. Rinse with fresh water and

allow to thoroughly dry.

STEEL: Scrape and wire brush or power tool clean to

remove loose rust, scale and deteriorated coatings. Use

7569 Red Primer for sound rusted or clean metal before

application of a finish coat. 7582 Gray Primer is best for

clean metal but may be used on sound rusted metal as

well.

PREVIOUSLY COATED: Previously coated surfaces must

be sound and in good condition. Smooth, hard, or glossy

finishes should be scarified by sanding to create a surface

profile. Removal of old paint by sanding, scraping or other

means may generate dust or fumes that contain lead.

LEAD IS TOXIC. EXPOSURE TO LEAD DUST CAN

CAUSE SERIOUS ILLNESS, SUCH AS BRAIN DAMAGE;

ESPECIALLY IN CHILDREN. PREGNANT WOMEN

SHOULD ALSO AVOID EXPOSURE. Wear a NIOSH

approved respirator to control lead exposure. Clean up

carefully with a HEPA vacuum and a wet mop. Before you

start, find out how to protect yourself and your family by

contacting the National Lead Information Hotline at
1-800-424-LEAD or log on to www.epa.gov/lead.

APPLICATION

Apply only when air and surface temperatures are

between 50-90°F (10-32°C) and relative humidity is below

85% to ensure proper drying.

Protect surrounding area from overspray.
Overspray can carry a significant distance.

Shake can vigorously for one minute after the mixing ball

begins to rattle. If mixing ball fails to rattle DO NOT

STRIKE CAN. Contact Rust-Oleum. Shake often during

use.  Hold can upright 10-16" from surface and spray in a

steady back-and-forth motion, slightly overlapping each

stroke. Keep the can in motion while spraying. Apply

2 or more light coats a few minutes apart to avoid drips and

runs.

DRY AND RECOAT

Dry and recoat times are based on 70°F(21°C)

and 50% relative humidity. Allow more time at cooler temperatures.

Dries to the touch in 15 minutes, to handle in 1-2 hours

and is fully dry in 24 hours. Primers can be top coated

immediately. Apply a second coat within 1 hour or after

48 hours.

CLEAN UP

Wipe off tip before storing. Clean-up wet paint with xylene

or mineral spirits. Properly discard empty container. Do

not burn or place in home trash compactor.

CLOGGING

If the valve clogs, twist and pull off spray tip and rinse in a

solvent such as mineral spirits. Do not insert any object

into can valve opening.