Seal-Krete 1 Gal Original Clear Waterproofing Primer/Sealer 100001

Description

Seal-Krete Original Waterproofing Primer/Sealer is a clear, waterborne, acrylic sealer, primer and binder for vertical concrete, brick, adobe, limestone, masonry and stucco surfaces. Recommended for use on painted aluminum siding, vinyl siding and galvanized metal. It seals and binds chalky surfaces, improving the adhesion of a topcoat. Can be used to help prevent efflorescence, erosion, spalling, rotting and other effects of water penetration. It has low odor, low VOC and is non-hazardous, non-staining and non-flammable. Cleans up with soap and water.

Extended Information

DESCRIPTION:

Penetrating clear satin waterproofer primarily for vertical

surfaces; water-based acrylic, low odor and low VOC.

Typical Uses:

✓

Seal brick, stucco & concrete

✓

Rejuvenate old brick & plaster

✓

Brighten aluminum siding

✓

Prime vinyl siding

✓

Bind chalky surface

✓

Paint additive to extend life & coverage

✓

Buffer pH in hot cement

✓

Dustproofing and priming floors

Important:

Read all directions thoroughly. Recommended: Wear gloves and

safety glasses.

SURFACE PREP*:

Surface must be clean and dry. Remove loose paint and

excessive chalk. Repair cracks and surface breaks. Cover windows, doors,

etc. and use caution when applying on windy days.

APPLICATION:

Read “LIMITATIONS” section before use. This sealer is

ready to use; do not dilute. Apply with a brush, roller or sprayer (garden or

airless). Backroll spray applications to ensure penetration. Apply at least two

coats, allowing two hours dry time between coats. Remove any overspray

immediately with water. Note: Sealer goes on milky white but dries clear.

COVERAGE:

80–300 sq.ft. per gal., depending on surface porosity. Second

coat application is 50% greater. Two coats are required for waterproofi ng

bare, vertical concrete.

DRY TIME:

2–4 hours, depending on temperature and humidity.

TOPCOATING:

May be topcoated with latex, oil-based or elastomeric coating

when dry.

TINT LIMITS:

Up to 4 oz. colorant per gallon.

PAINT ADDITIVE:

4–8 oz. of SEAL-KRETE Original can be mixed with one

gallon of latex paint to improve spread rate.

CLEAN-UP & STORAGE:

Clean all tools immediately after use with soap and

water. Store unused product in a dry place above 32°F (0°C). KEEP FROM

FREEZING.

LIMITATIONS:

Use on above grade vertical surfaces or as a primer on

horizontal surfaces – not for below grade use. Do not apply if rain is expected

within 12 hours or if temperatures fall below 50°F within 24 hours of

application. Do not use on swimming pools, bird baths, water features, cedar,

redwood or in areas where hydrostatic pressure is likely to develop. Do not

use on very porous substrates like low density, decorative block (use SEAL-KRETE Heavy-Duty instead).