Rust-Oleum Textured Spray Paint

Description

Rust-Oleum Stops Rust Textured Spray Paint provides distinctive, durable coating to metal, wood, concrete or masonry. Apply to chairs, tables, light fixtures, swing sets, tool chests and more. Dries into a textured finish for an upscale look.

PRODUCT FEATURES:
Fast-drying
Indoor/Outdoor
Durable, corrosion-resistant 

This Item Can NOT Be Shipped Internationally

Extended Information

Use outdoors or in a well ventilated area such as an open garage. Use when temperature is between 50F (10°C) and 90°F (32°C) and humidity is below 65% to ensure proper drying. Do not apply to surfaces, when heated, exceed 200°F (93°C). Do not

apply to galvanized steel. Avoid spraying in very windy and dusty conditions. Cover surrounding area to protect from spray mist.

SURFACE PREPARATION

Remove all dirt, grease, oil, salt and chemical contaminants by washing the surface with a commercial detergent, or other
suitable cleaning method. Rinse with fresh water and allow to thoroughly dry. Remove loose paint and rust with a wire brush or sandpaper. Previously coated surfaces must be sound and in good condition. Smooth, hard, or glossy finishes should be scarified by sanding to create a surface profile.

WARNING! If you scrape, sand, or remove old paint, you may release lead dust. LEAD IS TOXIC.

Contact the U.S.EPA/Lead Information Hotline at 1-800-424-LEAD or log on to www.epa.gov/lead.

PRIMING

Use of a Rust-Oleum primer provides added corrosion protection, excellent adhesion and hiding and is especially recommended for bare wood and metal. The following primers are recommended.

7769

Rusty Metal Primer

7780

Clean Metal Primer

PAINTING

Shake can vigorously for one minute after the mixing ball begins to rattle. If mixing ball fails to rattle DO NOT STRIKE CAN. Contact Rust-Oleum. Shake often during use. Hold can upright 10-16" from surface and spray in a steady back-and-

forth motion, slightly overlapping each stroke. Keep the can the same distance from the surface. Keep the can in motion while

spraying. Apply two or more light coats a few minutes apart to avoid drips and runs. Do not use near open flame.

DRY & RECOAT

Dry and recoat times are based on 70°F and 50% relative humidity. Allow more time at cooler temperatures. Dries to

touch in 15 minutes, dry to handle in 1-2 hours, and fully dry in 48 hours. Primers may be top coated immediately. Apply a

second coat or clear coat within 1 hour or after 48 hours.

CLEAN-UP

Wipe off tip before storing. Clean-up wet paint with xylene or mineral spirits. Properly discard empty container. Do not burn

or place in home trash compactor.

CLOGGING

If the valve clogs, twist and pull off spray tip and rinse in a solvent such as mineral spirits. Do not insert any object into

can valve opening.

Product Features