Rust-Oleum Reflective Finish Spray Paint 214944

Description

Rust-Oleum Specialty Reflective Finish Spray Paint illuminates painted surfaces under direct headlights for nighttime visibility and safety. Apply to metal, wood, plastic, concrete or masonry.

PRODUCT FEATURES:
Indoor/Outdoor
Semi-transparent finish

This Item Can NOT Be Shipped Internationally

Extended Information

PAINTING CONDITIONS

Use outdoors or in a well ventilated area such as an open

garage. Use when temperature is between 50°F (10°C) and

90°F (32°C) and humidity is below 65% to ensure proper

drying. Do not apply to surfaces, when heated, exceed 200°F

(93°C). Do not apply to galvanized steel. Avoid spraying in very

windy and dusty conditions. Cover surrounding area to protect

from spray mist.

SURFACE PREPARATION

Remove all dirt, grease, oil, salt and chemical contaminants

by washing the surface with a commercial detergent, or other

suitable cleaning method. Rinse with fresh water and allow to

thoroughly dry.

APPLICATION

Shake can vigorously for one minute after the mixing ball begins

to rattle. If mixing ball fails to rattle DO NOT STRIKE CAN. Contact

Rust-Oleum. IMPORTANT! Shake can approximately 4 seconds for

every 15 seconds of use. Hold can upright 10-16" from surface

and spray in a steady back-and-forth motion, slightly overlapping

each stroke. Apply 2-3 light coats 1-2 minutes apart. Keep the can

the same distance from the surface and in motion while spraying.

DO NOT APPLY HEAVY COATS THAT LOOK WET. The effect works

best when light coats are applied.

DRY & RECOAT TIMES

Dry and recoat times are based on 70°F (21°C) and 50% relative

humidity. Allow more time at cooler temperatures. The finish dries

to the touch in 1-3 hours. Allow 5-9 hours to handle and 24 hours

to dry fully.

CLEAN-UP

Clean valve immediately after use by turning can upside down

and depressing spray button for 3-5 seconds (some paint will be

sprayed out, so be careful to not inadvertently spray yourself or

other objects). Clean-up wet paint with xylene or mineral spirits.

Properly discard empty container. Do not burn or place in home

trash compactor.

CLOGGING

If the valve clogs, twist and pull off spray tip and rinse in a solvent

such as mineral spirits. Do not insert any object into can valve

opening.