Howard Restor-A-Finish

Treat Scratches, Nicks, and Abrasions - Restor-A-Finish works best when applied with a small pad of toweling, or for severe white rings and crazing, with Super Fine(0000) steel wool. DO NOT pour directly on the finish. When using steel wool, always rub with the grain of the wood. First, determine the pressure you should use on an inconspicuous spot, as the hardness of finishes vary.

Revive Wood Finishes - Wipe on the appropriate color of Restor-A-Finish with a clean cloth. Let it stand for a few minutes then wipe dry. If you desire a slightly darker shade, simply apply a darker color of Restor-A-Finish.

White Heat Rings and Water Marks- Apply Restor-A-Finish (see above) with steel wool and rub hard enough with the grain of the wood to blend out the white effect. If high gloss finish should appear dull due to the use of steel wool, polish it out with a Howard Polishing Compound or Burnishing Cream.

Raised and Blistered Finishes - Apply Neutral Restor-A-Finish (to prevent darkening of wood beyond temporary "wet effect") with steel wool. As blisters soften press down while the Restor-A-Finish is applied. Wipe dry, and again later if the surface "blooms" with excess Restor-A-Finish.

Restore Minor Crazed or Checked Finishes - Apply Restor-A-Finish with Medium Grade(00) steel wool. Rub hard enough to smooth out the finish, periodically checking your progress. Checked or crazed surfaces may absorb an excess of Restor-A-Finish and "bloom out" requiring another wiping later.

Treat Carved Wood - Restor-A-Finish has saved many hours of labor by restoring the finish on carved portions of furniture and clocks. Simply apply Restor-A-Finish with a small paint brush or soft tooth brush and wipe off.

- Be careful to protect fabric, carpets, and linoleum when applying Restor-A-Finish. It may leave a permanent stain. If spilling occurs, immediately scrub areas with straight liquid detergent or stain remover and wipe dry. Be sure to cover a small area at a time when applying Restor-A-Finish. Always wipe dry. DO NOT apply Restor-A-Finish to the new imitation wood finishes or use it under polyurethane finishes.