DAP 10 Oz Black High Heat Mortar 18854
|
DAP 10 Oz Black High Heat Mortar 18854 SKU: 18854-BOX |
Save by the box
Regular price
$52.92 Box of 12
$4.41 ea
|
||
DAP High Heat Fire Resistant Mortar is a non-combustible silicate cement used for patching chipped firebrick in fireplaces and sealing wood-burning stoves. Adheres firmly to the firebrick when wet or dry. Sets rock hard when fired. Can also be used for applications in wood frame construction where an ASTM E136 non-combustible sealant is required, such as sealing around vents, pipes, ducts, and chimneys at ceiling and floor level prior to the application of drywall products. It has been tested in accordance with ASTM E136 and withstands temperatures up to 2,000° F. DAP High Heat Mortar is not a fire-rated sealant as defined by Underwriters Laboratories and is not appropriate for fire-rated applications. Interior use only.
Surface Preparation & Application:
1. Prepare the application area by cleaning and removing dirt and debris.
2. For best adhesion, thoroughly dampen the surface with a brush and water before application.
3. Cut nozzle at 45° angle to an opening not less than ¼” x 1/8”.
4. Load cartridge into caulking gun.
5. Fill penetrations or voids with mortar.
6. Press mortar into crevices and smooth with a putty knife dipped in water.
7. Clean excess mortar from surface with a damp cloth.
8. Start a low burning fire until product dries (approximately 1 hour). Increase heat gradually to
harden the mortar (1-2 hours). Protect the mortar from direct water contact until fire
-cured. Joint width and depth should not exceed 1/8” x 1/8”. Multiple layers can be applied.
Allow 24 hours to cure between layers.
9. Fire-curing is not required until fill is complete.
For Best Results:
Use in temperatures between 40°F – 100°F.
Store caulk away from extreme heat or cold.
Do not use for automotive, marine or for below waterline applications.
Do not use in exterior applications, where excessive joint movement or frequent vibration may
occur, or in areas exposed to water or moisture. Product will etch glass and be impossible to
remove from glass or enamel surfaces if left to dry.
Applications:
Interior only
Shelf Life:
18 months when stored at 20°F
Coverage:
Approximately 122 linear feet at 1/8" diameter bead
Clean Up:
Remove unwanted mortar from surface immediately with a wet cloth. Dried mortar must be chipped
away.