PC11 has hundreds, if not thousands, of uses.
As Adhesive: Wood, Metal (all types), Glass, Brick, Block, Rubber, Concrete, Stone, Slate, Fiberglass, tile, and more in any and all combinations.
As Sealant: Oil, Gas, Water Tanks, Cellar Cracks, Pressure Tanks, and Plumbing Leaks.
As a Filler: Holes, Castings, Patterns, Molds, Voids, Welds, and much more.
Directions:
Using separate knives to remove amount needed, mix equal parts A (white) and B (pale blue) on a flat clean surface until uniform color is achieved. Surfaces to be bonded must be free of dirt, oil, rust, ect. Denatured alcohol can be used to prep the surface. For best results, rough up the surface PC-11® will be bonding to. Normally, no vice or clamp needed. Prop or tape heavy objects to a wall or ceiling.
Apply PC-11® in any thickness to both sides of surface and bring together firmly. Be careful to insure that ample PC-11® remains between the contact surfaces. Use screen wire or fiberglass cloth to reinforce large voids and gaps.
After cure: Paint Drill, Machine, Sand, File, Tap, or Saw.
|
|
