Home > Minwax >   Minwax Clear Brushing Lacquer
Minwax Clear Brushing Lacquer

Minwax® Clear Brushing Lacquer is a clear, protective finish for wood and metal. Minwax® Clear Brushing Lacquer dries to the touch in 30 minutes, ensuring a smooth, dust-free finish. It requires no sanding between coats. Item# Item Name List Price Our Price Qty Add 15200 Minwax Clear Brushing Lacquer Aerosol Gloss $8.39 $6.99 15210 Minwax Clear Brushing Lacquer Aerosol Satin $8.39 $6.99 15205 Minwax Clear Brushing Lacquer Aerosol Semi-Gloss $8.39 $6.99 15500 Minwax Clear Brushing Lacquer Quart Gloss $16.65 $13.89 15510 Minwax Clear Brushing Lacquer Quart Satin $16.65 $13.89 15505 Minwax Clear Brushing Lacquer Quart Semi-Gloss $16.65 $13.89 15000 Minwax Clear Brushing Lacquer Gallon Gloss $48.39 $40.35 15010 Minwax Clear Brushing Lacquer Gallon Satin $48.39 $40.35 15005 Minwax Clear Brushing Lacquer Gallon Semi-Gloss $48.39 $40.35 Check the items you wish to purchase, then click Technical Specs: 1. Surface must be dry and free of old finishes in poor condition, paint, wax, grease, polish, dirt or other foreign matter. Note: Do not apply lacquer over polyurethane finishes. 2. Sand to obtain a smooth, uniform surface. Remove all dust with a cloth dampened with mineral spirits. 3. Apply Minwax® Wood Finish™ stain or Minwax® Lacquer Sanding Sealer, if desired, following label directions. 4. Stir Minwax® Clear Brushing Lacquer well before and during use to rotate the product from the bottom to the top of the can. NEVER SHAKE. 5. Apply a coat of lacquer using a high quality natural bristle brush. On unfinished wood, apply sufficient lacquer to seal open joints, edges and end grain. 6. Let dry at least two hours, then apply a second coat. 7. Apply a third coat, repeating the steps above for each coat. Apply a fourth coat, if desired. 8. After final coat, allow at least 24 hours before normal use. CLEAN UP: For easy clean-up use lacquer thinner. COVERAGE: Approximately 125 sq. ft. per quart. Note: For brush application only. Above dry times and coverage rates are based on good ventilation, temperature of 77° F and 50% relative humidity. Lower temperature, higher humidity, lack of ventilation or application of thick coats will extend dry time. Always test tackiness between coats. Do not recoat if surface is still tacky. Slight ambering may be experienced when lacquer is applied over light-colored stains or wood surfaces. Always spot test on an inconspicuous area to ensure satisfactory results. Minwax® Clear Brushing Lacquer is not recommended for use on floors.

 Share your knowledge of this product with other customers... Be the first to write a review.

Browse for more products in the same category as this item: Minwax

	Purdy 5-Gallon Bucket Organizer
	Corona R-685 14" / 18" Industrial Frame Standard
	Wooster Flawless Paintbrush
	Wooster Ex Magikage
	Purdy Contractor 1st Roller Covers
	Corona White Fitch
	Professional Painters Angle Short Handle Brushes
	SHUR-LINE Line Marker
	Wooster ALPHA Wall